In November 2008, Mazda improved the RX-8 body rigidity through the addition of structural reinforcements, by adding a trapezoidal shock tower brace and enhancing the local rigidity of the front suspension tower areas. The rear suspension geometry was revised for better handling, and the final-drive-gear ratio on manual transmission cars was shortened from 4.444 to 4.777 for improved off-the-line performance. While minimal, these changes gave the updated RX-8 increased acceleration and performance. Mazda engineers claimed that the 2nd generation RX-8 was (slightly) faster than the previous generation due to the lower gearing and improved suspension. The Renesis II engine iteration that was launched in the 2009 model year included a third oil injection port in each rotor housing to feed oil to the middle of the rotor facing, making this their first all-new EMOP (Electric Metering Oil Pump) with a total of 6 lubrication injectors, plus an all-new engine oil pump with higher pressure rating that requires specific oil filter rated for the higher pressure. New catalytic converter was used to reduce clogging that resulted in overheating exhaust stream forward of the catalytic converter and eventual rotor side seal failure, which was responsible for majority of RX-8 engine failures. Ignition coil packs, which suffer reduced performance over time and leads to unburnt fuel and oil that eventually clogs the catalytic converter, was not upgraded from series 1 RX-8. Due to higher usage cycle that is two to three times higher in Wankel compared to Otto cycle, ignition coil packs on RX-8 can degrade much sooner than Piston engines using similar hardware, and cause unburnt fuel to reach the catalytic converter, clogging it and cause engine overheating leading to side seal springs failure.
The updated RX-8 also received design enhancements that were meant to freshen the styling and give the RX-8 a new look, without impairing the basic design theme. Refinements for the 2009 model year included a more aggressive restyled front and rear bumper as well as a new front fascia. The updated RX-8 also came with sporty, high-quality finish front and rear headlamps as well as larger exhaust pipes (now measuring 90 mm (3.5 in) across). The 2009 RX-8 also offered a new five-spoke wheel design featuring a symbolic and sporty design reminiscent of the rotary engine, with different arrangements for each wheel size. A rear spoiler was also added dependent on the trim level selected. There were three trims available to consumers from 2009 to 2012: Sport, Grand Touring, and R3.
The R3 version was first introduced in 2005 in Japan. This version was very limited and had the 1.3 L RENESIS Wankel engine and a Bose sound system. The R3 model was again introduced in 2009. The 2009 R3 package added slightly improved suspension over the base model by adding Bilstein shock absorbers and a foam filled front crossmember to improve rigidity. It also came with 19-inch forged aluminum-alloy wheels and high performance tires. On the exterior, the R3 had a different, lower front bumper sporting a splitter, lower side sills, and a standard rear spoiler. There is a pair of special Recaro seats up front, along with the same 300-watt Bose audio system, along with Bluetooth and the Mazda advanced keyless entry and start system. No electric sunroof was offered in the R3 model.
Sound by: Dian Smit
Modifications Include:
Brembo Big Brake Kit
Mazda Speed Exhaust System
HKS Hipermax 4 GT Coilovers
Eibach ARBs
Eunos Cosmo 20B built by Rotary Revs UK
Ings Bodykit
Voltex Wing
The updated RX-8 also received design enhancements that were meant to freshen the styling and give the RX-8 a new look, without impairing the basic design theme. Refinements for the 2009 model year included a more aggressive restyled front and rear bumper as well as a new front fascia. The updated RX-8 also came with sporty, high-quality finish front and rear headlamps as well as larger exhaust pipes (now measuring 90 mm (3.5 in) across). The 2009 RX-8 also offered a new five-spoke wheel design featuring a symbolic and sporty design reminiscent of the rotary engine, with different arrangements for each wheel size. A rear spoiler was also added dependent on the trim level selected. There were three trims available to consumers from 2009 to 2012: Sport, Grand Touring, and R3.
The R3 version was first introduced in 2005 in Japan. This version was very limited and had the 1.3 L RENESIS Wankel engine and a Bose sound system. The R3 model was again introduced in 2009. The 2009 R3 package added slightly improved suspension over the base model by adding Bilstein shock absorbers and a foam filled front crossmember to improve rigidity. It also came with 19-inch forged aluminum-alloy wheels and high performance tires. On the exterior, the R3 had a different, lower front bumper sporting a splitter, lower side sills, and a standard rear spoiler. There is a pair of special Recaro seats up front, along with the same 300-watt Bose audio system, along with Bluetooth and the Mazda advanced keyless entry and start system. No electric sunroof was offered in the R3 model.
Sound by: Dian Smit
Modifications Include:
Brembo Big Brake Kit
Mazda Speed Exhaust System
HKS Hipermax 4 GT Coilovers
Eibach ARBs
Eunos Cosmo 20B built by Rotary Revs UK
Ings Bodykit
Voltex Wing
